Scanned Area Of A Document; Setting Up Documents; Placing A Document On The Platen Glass - Canon LASERBASE MF5700 Series User Manual

Scanned Area of a Document

The shaded area in the illustration below shows the scanned area of a document. Make sure your
document's text and graphics are within this area.
3

Setting Up Documents

For scanning, place your documents on the platen glass or load them in the ADF. Where you set up
your documents depends on the size and type of documents you want to scan. (See "Document
Requirements," on p. 3-1.)

Placing a Document on the Platen Glass

1
Open the platen glass cover.
2
Place your document face down on the platen glass.
Use the paper size marks on the left side of the platen glass to position a document.
•
If your document conforms to a standard paper size (e.g., A4 or A5), align the document between the
appropriate paper size marks.
•
If you do not know the size of your document, or if your document does not match any of the paper size marks,
align the center of your document with the ➞ mark.
3-2
MAX. 5.5 mm
Scanning
direction
MAX. 5.5 mm
MAX. 3 mm
A4
MAX. 3 mm