Operation; Operating A Basic Microgt 500 Pv System - Magnum Energy MicroGT 500 Owner's Manual

Hide thumbs Also See for MicroGT 500:

Table of Contents

Operation

3.0

Operation

To operate a batteryless MicroGT 500 inverter PV system:

1. Turn on the AC circuit breaker on each MicroGT inverter branch

circuit.

2. Turn on the main utility grid AC circuit breaker. Your system will

start producing power after a ﬁ ve-minute wait time.

Note: Five minutes after turning on the AC circuit breaker, the

units' LEDs should start blinking green every 2 seconds. This

means they are producing power normally, but have not yet

connected to the MagWeb GT.

3. Plug in the MagWeb GT and follow instructions per your MagWeb

GT Owner's Manual.

Once the MagWeb GT has been plugged in and acknowledges

the MicroGT inverters, the microinverters will start to blink

every 10 seconds.

Note: The time required for all microinverters in the system

to report to the MagWeb GT will vary with the number of

microinverters in the system. Once communications have been

established between the MagWeb GT and the microinverters, the

microinverters will start to send performance data over power

line to the MagWeb GT. You can verify the proper operation of the

MicroGT inverters via the MagWeb GT.

Refer to the MagWeb GT Owner's Manual for more information

on its operation.

Table of Contents