Tonal Signal Test - Muratec MFX-2050 Field Engineering Manual

3.14.2 Tonal Signal Test

The tonal signal test permits the unit's output tones to be monitored.
Note: To monitor the tones, an external monitoring device must be connected to the telephone line
jack.
1. Press <Setting>, <*>, <1>, <2>.
2. Select the line you want to test. If the optional second phone line is not attached, you can only test
line1.
3. Select [Tonal].
4. Select your desired tonal signal test. When it is selected, it will be highlighted.
Refer to the table below.
Note: It may take several moments for output signal to change.
Signal
None (stop signal)
400 Hz tone
600 Hz tone
1100 Hz tone
1300 Hz tone
2100 Hz tone
3000 Hz tone
3400 Hz tone
FSK WHITE
FSK BLACK
FSK _W1_B1
V27_1200_2400 picture date
V27_1600_4800 picture date
V29_2400_7200 picture date
V29_2400_9600 picture date
V17_2400_7200_W1_B0 picture date
V17_2400_7200_W1_B1 picture date
Signal
V17_2400_7200_W1_B4 picture date
V17_2400_7200_W0_B1 picture date
V17_2400_7200_W4_B1 picture date
V17_2400_9600_W1_B0 picture date
V17_2400_9600_W1_B1 picture date
V17_2400_9600_W1_B4 picture date
V17_2400_9600_W0_B1 picture date
V17_2400_9600_W4_B1 picture date
V17_2400_12000_W1_B0 picture date
V17_2400_12000_W1_B1 picture date
V17_2400_12000_W1_B4 picture date
V17_2400_12000_W0_B1 picture date
V17_2400_12000_W4_B1 picture date
V17_2400_14400_W1_B0 picture date
V17_2400_14400_W1_B1 picture date
V17_2400_14400_W1_B4 picture date
V17_2400_14400_W0_B1 picture date
V17_2400_14400_W4_B1 picture date
3-122