Installing A Full-Height Media Device - HP ProLiant DL G6 User Manual

Slide the media device part of the way into the bay.
10.
Connect the server data and power cables to the rear of the device.
11.
Slide the media drive fully into the bay until it is seated securely.
12.
Install the fan cage.
13.
Install the air baffle.
14.
If removed, install the BBWC battery pack or the FBWC capacitor pack
15.
pack or the FBWC capacitor
Install fan 5.
16.
Install the access panel.
17.
Do one of the following:
18.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 22,
19.

Installing a full-height media device

Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove fan 5 (on page 26).
4.
If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27).
5.
Remove the air baffle (on page 28).
6.
Remove the fan cage (on page 29).
7.
Remove the media bay blank (on page 30).
8.
Remove the DVD-ROM drive (on page 31).
9.
pack" on page 86).
"Powering up and configuring the
("Open or remove the tower
("Installing the BBWC battery
server" on page 40).
bezel" on page 22).
Hardware options installation 74