Installing The Six-Bay Lff Backplane (Bay 2) - HP ProLiant DL G6 User Manual

Route and connect the SAS cables.
13.
Install the fan cage.
14.
Install the air baffle.
15.
Install fan 5.
16.
If removed, install the BBWC battery pack or the FBWC capacitor pack
17.
pack or the FBWC capacitor
Install the access panel.
18.
Do one of the following:
19.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
CAUTION:
all bays are populated with either a component or a blank.
Install the hard drives and hard drive blanks.
20.
Power up the server (on page 22,
21.

Installing the six-bay LFF backplane (bay 2)

To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove fan 5 (on page 26).
4.
If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27).
5.
Remove the air baffle (on page 28).
6.
pack" on page 86).
To prevent improper cooling and thermal damage, do not operate the server unless
"Powering up and configuring the
("Installing the BBWC battery
server" on page 40).
("Open or remove the tower
Hardware options installation 67
bezel" on page 22).