Advertisement
SLB Branch Offi ce Manager Quick Start Guide
5 LOGGING INTO THE SLB WEB PAGE
This section includes instructions for accessing both the web page and the command line interfaces. You can use either method to
configure all parameters.
To log in to the SLB web page:
1. Open a web browser.
2. In the URL field, type https:// followed by the IP address of your SLB.
3. At the first login, enter sysadmin (all lower case) as the user and PASS (for older devices) or the last 8 characters of the Device ID
(for devices manufactured after firmware release 7.0.0.0) as the factory default password. If the Device ID is not set, the password
is the last 8 characters of the Serial Number. The Device ID and Serial Number can be viewed on the LCD.
The first time you log in, the SLB Quick Setup page displays. Subsequent logins display the SLB Home Page. (To display Quick
Setup again, click the Quick Setup tab.)
4. Do one of the following:
• To bypass the Quick Setup page and go directly to configuring the SLB, click the Accept default Quick Setup settings checkbox
and click Apply.
• Update basic network parameters, if desired and click Apply.
6 LOGGING INTO THE COMMAND LINE INTERFACE
To access the command line interface
1. Do one of the following:
• With a network connection, use a Telnet or SSH program to Telnet or SSH to xx.xx.xx.xx (the IP address in dot quad notation), and
press Enter. You should be at the login prompt.
Note: By default, Telnet is disabled. To enable Telnet, use the Services web page, a serial terminal connection, or an SSH connec-
tion.
• With a serial terminal connection, when the command line displays, press Enter.
2. Enter sysadmin as the user name and press Enter.
3. Enter PASS (for older devices) or the last 8 characters of the Device ID (for devices manufactured after SLB firmware release
7.0.0.0) as the factory default password and press Enter. The first time you log in, the Quick Setup script opens automatically. Sub-
sequent logins display the command prompt only. (To obtain the Quick Setup script again, use the admin quicksetup command.)
Note: Change the default password as soon as possible to prevent access by unauthorized personnel.
4. If the Quick Setup script displays, update basic network parameters, as desired. Otherwise, just press Enter until the command
prompt displays.By pressing Enter, you are accepting the current settings.
Notes:
• For general command line interface help, type help command line.
• For help with a specific command, type help followed by the command, for example,help set network or help admin firmware.
Contact
Technical Support
For technical support queries, visit http://www.lantronix.com/support.
Latest Firmware For the latest firmware downloads, visit
© 2023 Lantronix, Inc. Lantronix and SLB are trademarks of Lantronix, Inc., registered in the U.S. and other countries. Specifications subject to change without notice. All other trademarks and trade names are the
property of their respective holders. 900-670-R Rev J
http://www.lantronix.com/support/downloads
3
Advertisement
