Assembly - Grizzly G0621 Owner's Manual

Assembly

To assemble the bandsaw:
1.
install the rubber feet into the bottom of the
cabinet stand, as shown in figure 5, with the
four ⁄ "-18 x 1" hex bolts, four
5
16
ers, and four ⁄ "-18 hex nuts.
5
16
figure 5. rubber foot order of installation.
The bandsaw is heavy
and awkward to lift. use a
forklift or other powered
lifting aid.
2. Using a forklift or other powered lifting aid,
place the bandsaw on top of the stand.
3. Align the mounting holes on the bandsaw
base with those in the stand.
4.
secure the bandsaw to the stand with the
four ⁄ "-18 x 3" hex bolts, eight
5
16
ers, and four ⁄ "-18 hex nuts (figure 6).
5
16
figure 6. Bandsaw mounted to stand.
Model g0621 (Mfg. since 10/06)
⁄ " flat wash-
5
16
Hex Bolt
Foot
Flat
Washer
Hex Nut
⁄ flat wash-
5
16
5.
thread a ⁄ "-16 hex nut half way up the posi-
3
8
tive stop bolt (hex Bolt
6.
thread the positive stop bolt into the trunnion
base so it is installed as shown in figure 7.
positive
stop
Bolt
figure 7. positive stop bolt installed.
7. remove the table pin from the table.
8.
Fit the table around the blade and rest the
table trunnions on the trunnion base, making
sure the trunnion bolts extend through the
bottom of the trunnion base.
9. thread the two table trunnion knobs onto the
trunnion bolts, as illustrated in figure 8.
Table
figure 8. table installation on trunnion base.
3 ⁄ "-16 x 3 1 ⁄ ").
8 2
Table Trunnion
Trunnion Base
Trunnion Bolt
Trunnion Knob
-15-