Adjusting Blade Guides - Grizzly G0621 Owner's Manual

Adjusting Blade
Guides
the blade guides provide side-to-side support to
help keep the blade straight while cutting. the
blade guides adjust in two ways—forward/back-
ward and side-to-side. properly adjusted blade
guides are essential to making accurate cuts.
To adjust the upper and lower blade guides:
1.
Make sure the blade tracks properly and is
correctly tensioned.
2.
disConnECt BAndsAW FroM poWEr!
3.
Familiarize yourself with the blade guide con-
trols shown in figure 24.
Blade guide
thumbscrews
figure 24. Blade guide controls.
4.
loosen the lateral adjustment thumbscrew.
5. slide the guide assembly so the front edges
of the blade guides are just behind the blade
gullets as illustrated in figure 25.
-22-
6.
lateral 7.
Adjustment
thumbscrew 8.
9.
10. remove the dollar bill, then re-install the
Blade
Gullets
figure 25. lateral adjustment of blade guides.
NOTICE
Make sure the blade teeth will not contact
the blade guides during operations or the
tooth set on the blade will be ruined.
tighten the lateral adjustment thumbscrew.
loosen the blade guide thumbscrews.
Fold a crisp dollar bill in half and place it over
the blade (between the blade guides and the
blade), as shown in figure 26.
figure 26. Blade guides against both sides of
blade.
lightly pinch the dollar bill against the blade
with the blade guides, then tighten the blade
guide thumbscrews.
blade guard.
Model g0621 (Mfg. since 10/06)
Blade
Guide