Stand Legs (Optional Accessory); Stand Shelf; Controls And Features - Jet JWL-1442VS Owner's Manual

Stand Legs (optional accessory)

1. At this point the headstock, tailstock and tool
rest should be removed.
another person lift the lathe bed and place
onto a workbench.
2. Angle lathe bed so that stand leg mounting
holes are accessible, see Figure 2.
3. Thread adjustable feet (A, Fig. 2) into stand
leg (B, Fig. 2). There is a flat spot on the
shaft near the foot that will accommodate a
wrench. Thread a hex nut (C, Fig. 2) onto
shaft and leave loose for now.
4. Mount the leg to lathe bed with four 5/16" flat
washers and four 5/16"-18 x 1-1/2" hex
socket cap screws (D, Fig. 2).
5. Repeat for the other leg.
6. Adjust the feet so that the lathe rests evenly
on the floor, and tighten the nuts.
7. Reinstall headstock, tailstock and tool rest.

Stand Shelf

You can make an extra shelf that rests between
the legs if you wish, see Figure 3. It will be
useful for storing lathe accessories, or adding
sand bags for some extra weight.
2x4's should be 55-3/4" long.
should be ripped into two equal
27-13/16"L x 17"W so that it can be assembled
between the legs. Use screws to attach the
plywood to the 2x4 supports.
Controls & Features
E. Headstock Lock Handle: (E, Fig. 4)
Locks the head in position.
handle to position the head in any location
along the lathe bed. Tighten handle when
properly positioned.
F. Headstock Indexing Pin: (F, Fig. 4)
Turn the knurled knob counter-clockwise to
unlock the plunger.
release the headstock.
headstock locking handle and rotate the
headstock. Turn knurled knob clockwise
until it stops to lock plunger.
With help from
The two
The plywood
pieces
Unlock the
Pull the knob out to
Unlock the
10