Shipping Contents; Contents Of The Shipping Containers; Unpacking And Clean-Up; Assembly - Jet JWL-1442VSK Operating Instructions And Parts Manual

Read and understand the entire
contents of this manual before attempting
assembly or operation! Failure to comply may
cause serious injury.

Shipping Contents

Contents of the Shipping Containers

1 Lathe with Leg Set
1 Tailstock
1 Headstock
1 Face Plate
1 Tool Rest Body
1 Accessory Package
1 Owner's Manual and Warranty Card
Accessory Package Box
1 Live Center
1 Spur Center
1 Index Pin
1 Wrench
1 Drift Rod
1 Tool Rest
1 Tool Rest Extension
4 Adjustable Feet

Unpacking and Clean-Up

1. Remove the shipping container. Do not discard
any shipping material until the lathe is set up
and running properly.
2. Remove tailstock, tool rest and headstock
before lifting; see "Adjusting the Clamping
Mechanism" on Page 19 on how to remove the
tailstock, headstock or tool rest.
3. Remove hex cap bolts from skid bottom and lift
the lathe bed, with the help from another
person, off the skid and onto the edge of a
workbench, as shown in Figure 1.
4. Clean all rust protected surfaces with a
cleaner-degreaser. Clean under the headstock,
tailstock and tool rest body.

Assembly

Stand Legs

At this point the headstock, tailstock and tool rest
should be removed. With help from another person,
lift the lathe bed and place onto a workbench.
1. Angle lathe bed so that stand leg mounting
holes are accessible, see Figure 1.
Contents of Accessory Package
7
708358K
Figure 1