imagistics im7520 User Manual page 91

12
8
Press the [Start] key.
A test pattern is printed.
9
Touch [Close].
The Leading Edge Adjustment screen appears again.
10
Check the distance (a)
from the starting print
position of the test pat-
tern to the edge of the
paper.
11
If the desire print results are not achieved, change the adjustment
– To increase distance (a), touch [+].
– To reduce distance (a), touch [–].
– To scroll through the values quickly, touch [+] or [–] continuously.
12
Repeat steps 7 through 11 until the desired print results are achieved.
13
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
12-42
a
Utility
im7520/im6020