imagistics im7520 User Manual page 100

Utility
– If the punch positions are too far below the center of the paper,
touch [–] (between –0.1 mm and –5.0 mm).
13
Repeat steps 7 through 12 until the desired print results are achieved.
14
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
When im9220010 and 9263 are installed, adjustments can be made using
both the "Punch Adjustment" and "Z-Fold Position Adjustment" param-
eters. Contact your technical representative.
im7520/im6020
12
12-51