NetComm 4G100W User Manual page 36

WPS
WPS is the simplest way to establish a connection between wireless clients and your 4G100W. This method removes the need to
manually select the encryption mode and fill in the passphrase key. You only need to press a button on both wireless client and the
4G100W, and the WPS will do the rest for you. The 4G100W supports two types of WPS:
WPS via Push Button – You have to push a specific button on your wireless client or in your wireless client utility to
start WPS mode. On the 4G100W, set WPS to Enable and click Apply.
WPS via PIN code - You have to know the PIN code of the wireless client and switch it to WPS mode, then enter the
wireless client PIN to the 4G100W web interface.
Use the drop down list to enable or disable the WPS function, then click Apply.
OPTION
Status
WPS Configured
SSID
WPS Auth Mode
WPS Encrypt Type
WPS PIN
WPS Mode
YMLN4G100W
www.netcommwireless.com
Figure 31 - WPS Settings
If the wireless security (encryption) function of this wireless router is properly set, you will see a 'Success' message
here. Otherwise, you will see 'Idle'.
Shows the whether WPS has been configured.
This is the network broadcast name (SSID) of the router.
It shows the active authentication mode for the wireless connection.
Shows the type of wireless encryption used to establish a connection using WPS.
This is the WPS PIN code of the wireless router. You may need this information when connecting to other WPS-
enabled wireless devices.
Select either PIN mode or PBC (which is WPS via Push Button).
Table 19 - WPS Settings Description
DEFINITION
4G LTE WiFi Router
36