Connecting The Phone To The Network; Setting Up The Polycom Hdx Or Polycom Realpresence Group System - Polycom 7000 Integration Manual

Integration Guide for the Polycom SoundStation IP 7000 Phone Connected to a Polycom HDX System or Polycom RealPresence Group
System in Unsupported VoIP Environments

Connecting the Phone to the Network

Note
Note
Setting Up the Polycom HDX or Polycom RealPresence Group
System
6
Connecting the SoundStation IP 7000 conference phone to the network is optional,
but highly recommended (for the reasons discussed at the beginning of this
chapter).
The following figure shows how to connect the phone to the network.
1
To connect the SoundStation IP 7000 phone to the network:
1. Connect the 7.6m (25ft) Network Cable to the LAN jack on the phone.
2. Connect the other end of the 7.6m (25ft) Network Cable to an available
LAN port on the wall or hub/switch device port.
AC power adapters are not included in the basic phone package. Power will be
provided to the phone from the Polycom HDX or Polycom RealPresence Group
system when connected using the Polycom Microphone Array Cable.
For information on installing the Polycom HDX or Polycom RealPresence
Group system, refer to the Setup Sheet for your system. For information on
configuring the system, refer to the Administrator's Guide for your system.
Both documents are available by navigating to your system from the
Support Web page.
2
7.6m (25ft)
25-foot Network Cable
Video