Chain in the frame tunnel
Remove the frame plate by loosening the four screws.
Lubricate the chain in the frame tunnel with an oil can or chain
lubricant spray for motorcycles.
Links and joints in the cutting
adjustment
Lubricate the links and the joints for the cutting height
adjustment cable behind the right front wheel. Lubricate using
an oilcan.
Driver's seat
Fold up the seat.
Lubricate the lengthways adjustment runners with the oil can.
LUBRICATION
Throttle and choke cables, lever
bearings
•
Remove right wing cover, see "Dismantling the Rider
covers" on page 23. Open the engine cover.
•
Lubricate the cables' free ends with the oil can, even those
by the engine.
•
Move the controls to the end points and lubricate again.
•
Lubricate the joints, catches, and bearings for the cutting
deck's control levers with an oil can.
Put back the right wing cover.
Lubricate the hydrostatic cable with
links
Lubricate the joints and bearings on the left side with an
oilcan. Remove the rubber casing and lubricate the
hydrostatic transmission cable with an oilcan.
Depress the pedal a few times, lubricate again, and put back
the rubber casing.
– 35
English