Main Fuse; Checking The Tyre Pressures; Checking The Engine's Cooling Air Intake - Husqvarna P 524 Operator's Manual

5 Lift out the bulbs from the insert.
6 Insert the new bulbs. Make sure you use your thumb to
support the front.
7 Refit the cables, lamp insert and the cover in the reverse
order.

Main fuse

The main fuse is placed in a detachable holder under the
battery. Type: Flat pin fuse, 20 A.
The fuse for the power outlet is placed under the control
panel. Type: Flat pin fuse, 5 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
MAINTENANCE

Checking the tyre pressures

The tyre pressure must be 100 kPa / 1.0 bar / 14.5 PSI for the
front and rear wheels.
IMPORTANT!
Different air pressure in the front tyres will result in the
blades mowing the grass at different heights.
Checking the engine's cooling air
intake.
!
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
Check that the engine cooling air intake is free of leaves,
grass, and dirt.
WARNING!
The cooling air intake rotates when the
engine is running. Watch your fingers.
– 27
English