Checking The Oil Level Of The Hydraulic System; Hydraulic Oil Filter, Change; Checking The Transmission Oil Level; Checking The Oil Level Of The Engine - Husqvarna P 524 Operator's Manual

Checking the hydraulic system's oil
level
The oil and filter should be changed by an authorised service
representative, as described in the Workshop Manual. Work
on the system entails particular demands on cleanliness and
the system must be vented before the machine is used.
• Fold up the seat.
• Remove the filler cap. The level must be 40 to 60 mm from
the upper edge of the screen.
• Refill if needed with a fully synthetic 10W/50 API SM oil or
better
Hydraulic oil filter, change
• Turn the old oil filter anti-clockwise to remove. If
necessary, use a filter remover.
• Lightly lubricate the rubber seal on the new oil filter using
new oil.
• Mount the filter by hand with + 3/4 turn. Fill the
transmission's oil tank with approx. 0.3 litres of oil. Be
observant when running the engine as described below
and fill so that the tank is not emptied.
Run the engine, manipulate the servo steering, and then
check that there are no leaks around the oil filter seal.
• Check the oil level in the transmission, top up if necessary.
The oil filter holds 0.3 litres of oil.
36 –
English
LUBRICATION
Checking the oil level in the
transmission
• Check that there is oil in the transmission with the dipstick.
• The oil level should be between the markings on the
dipstick.
• Refill if needed with a fully synthetic 10W/50 API SM oil or
better.
Checking the engine's oil level.
Check the oil level in the engine when the Rider stands
horizontal with the engine switched off.
Open the engine cover.
Loosen the dipstick, pull it up and wipe it off.
Now insert the dipstick again, without tightening it.
Pull the dipstick out again and read the oil level.
The oil level should be between the markings on the dipstick.
If the level is approaching the ADD mark, top up the oil to the
FULL mark on the dipstick.
The oil is topped up through the hole the dipstick sits in. Fill
the oil slowly.