Inspecting The Blades; Removal Of Bioclip Plug - Husqvarna P 524 Operator's Manual

2 Open the lock for the track rod bolt.
Remove the bolt so the track rod is released in one end.
3 Unscrew the bolt holding the cutting deck frame bracket.
4 Remove the lock and draw out the cutting deck frame.
5 Remove the two bolts on the cutting deck frame.
6 Remove the screws on the cutting cover. Lift the cutting
deck frame and remove the cutting deck cover.
32 –
English
MAINTENANCE
7 Loosen the spring that tensions the V-belt and wriggle the
belt off.
Attach a new belt in the reverse order.

Inspecting the blades

It is important that the blades are undamaged and well-
ground to give the best mowing result.
Check that the blades' mounting bolts are tightened.
IMPORTANT!
Replacement or sharpening of the blades should be carried
out by an authorised service representative.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the servicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
Removal of the CombiClip plug
To change a Combi unit from the CombiClip function to a
cutting deck with rear ejection, remove the CombiClip plug,
which is located under the unit, attached with three screws.
1 Put the cutting deck in service position, see "Placing in the
service position" on page 30.
2 Remove the three screws holding the CombiClip plug, and
remove the plug.
3 Tip: Fit three full-thread screws M8x15 mm in the screw
holes to protect the threads when removing the CombiClip
plug.
4 Return the cutting deck to the normal position.
Fit the CombiClip plug in the reverse order.