Power Connector Cable - HP Envy Maintenance And Service Manual

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the display panel (see
5.
Remove the service cover (see
6.
Remove the battery (see
7.
Remove the RJ-45 module cover (see
8.
Remove the USB/audio board (see
Remove the power connector cable:
1. Remove the 2 Phillips PM2.5×5.5 screws that secure the left display hinge to the computer, and
then rotate the hinge upward (2).
2. Disconnect the power connector cable from the system board (1), and then remove the cable from
the clip build into the fan (2).
3. Remove the 2 Phillips PM2.5×3.5 broadhead screws that secure the bracket that sits atop the
power connector (3).
Display assembly on page
Service cover on page
Battery on page 39).
RJ-45 module cover on page
USB/audio board on page
74).
37).
49).
52).
Component replacement procedures
Spare part number
736358-001
53