Ethernet Client Filter - Billion BiPAC 6404VGP R3 User Manual

Ethernet Client Filter

The Ethernet Client Filter can support up to 16 Ethernet network computers. It enables you to
accept traffic from specific authorized computers or can restrict unwanted computer(s) to access
your LAN.
There are no pre-defined Ethernet MAC address filter rules, you can add the filter rules to meet your
requirements.
Ethernet Client Filter: Default setting is set Disable.
Allowed: check to enable a specific PC to access your LAN by inserting the MAC Address in
the space provided or click the Candidate button. Make sure your PC's MAC is listed.
Blocked: check to prevent an unwanted PC from accessing your LAN by inserting the MAC
Address in the space provided or click the Candidate button. Make sure your PC's MAC is not
listed.
The maximum number of client is 16. The MAC addresses should be 6 bytes long and are presented
only in hexadecimal characters. Only numbers (0 - 9) and letters (a - f) are acceptable.
Note: Follow the MAC Address Format xx:xx:xx:xx:xx:xx. Semicolon ( : ) must be included.
Candidates: automatically detects devices that are connected to the router through the Ethernet.
Click the Candidate button to access the Active PC in LAN window.
Active PC in LAN: Active PC in LAN window displays a list of IP Address & MAC Address of each
Ethernet device which connects to the router.
You can check the checkbox next to the IP address to block or to allow the PC from accessing the
LAN. Then, click Add to insert the IP to the Ethernet Client Filter table. The maximum number of
supported Ethernet client is 16.
38