Billion BiPAC 7404VNOX User Manual page 105

Inbound: Internet to LAN
Outbound: LAN to Internet
YES: Allowed
NO: Blocked
N/A: Not Applicable
Packet Filter – Add TCP/UDP Filter
Rule Name Helper: Users-define description to identify this entry or click "Select" drop-down menu to
select existing predefined rules. The maximum name length is 32 characters.
IP version: select IPv4 or IPv6.
Time Schedule: It is self-defined time period. You may specify a time schedule for your prioritization
policy. For setup and detail, refer to Time Schedule section
Source IP Address(es) / Destination IP Address(es): This is the Address-Filter used to allow or
block traffic to/from particular IP address(es). Selecting the Subnet Mask of the IP address range you
wish to allow/block the traffic to or form; set IP address and Subnet Mask to 0.0.0.0 to inactive the
Address-Filter rule.
Tip: To block access, to/from a single IP address, enter that IP address as the Host IP Address and
use a Host Subnet Mask of "255.255.255.255".
Type: It is the packet protocol type used by the application, select TCP, UDP or both TCP/UDP.
Protocol Number: Insert the port number.
Source Port: This Port or Port Ranges defines the port allowed to be used by the Remote/WAN to
connect to the application. Default is set from range 0 ~ 65535. It is recommended that this option be
configured by an advanced user.
Destination Port: This is the Port or Port Ranges that defines the application.
Inbound / Outbound: Select Allow or Block the access to the Internet ("Outbound") or from the
Internet ("Inbound").
Click Add button to apply your changes.
102