Casablanca AURORA Owner's Manual page 11

Warning: To reduce the risk of electrical shock, this fan must be installed with an
isolating wall control/switch.
W-42
CONTROL
VERSA•TOUCH
CAUTION! Do not use with wall dimmer.
STANDARD
TOGGLE
SWITCH
SWITCH
COVER
PLATE
Standard Light Switch
Step 1. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step 2. Orient the control holder as shown and line up
the two inner mounting holes with those on the switch.
Step 3. Install and tighten screws by hand only.
VERSA•TOUCH
Wall Installation
Step 1. Locate a
2X4 wall stud in a
convenient loca-
tion.
Step 2. Orient the
control holder as
shown over the
2X4 stud.
Step 3. Use the 1"
wood screws in ei-
ther the inner or
outer mounting
holes.
Install and tight-
en screws by hand
only.
Remove Battery Door
Turn control on its
front.
Twist a coin to unsnap
the door A. Lift door
away from control B
and remove C.
Changes or modifications not expressly approved in writing by Casablanca Fan Co. may void
the user's authority to operate this equipment.
SAFETY FIRST
VERSA•TOUCH
W-42
CONTROL
HOLDER
9V BATTERY
CONTROL HOLDER INSTALLATION
INNER
MOUNTING
HOLES
CONTROL
HOLDER
STORING CONTROL IN HOLDER
WOOD
SCREW 1"
VERSA•TOUCH
INSTALLATION
DRYWALL
ANCHOR
6-32
(2)
REMOVE TABS
ROCKER
TYPE
LIGHT
SWITCH
SWITCH
COVER
PLATE
Rocker Light Switch
Step 1. Break off the two tabs by pushing outward.
Step 2. Remove the two screws holding the switch cover plate. Do
not remove the cover plate.
Step 3. Orient the control holder as shown and line up the two outer
mounting holes with those on the switch.
Step 4. Install and tighten screws by hand only.
Note: The wall anchors and
6-32 x 1" screws may be used
in situations where mounting
to a stud is not possible. Use
the inner mounting holes.
After securing the anchor, dis-
card the anchor's pointed
screws and use the 6-32 de-
cor ovalhead screws supplied.
ANCHOR
PANHEAD
SCREW
DRYWALL ANCHOR
DECOR OVALHEAD SCREW
6-32 X 1"
BATTERY INSTALLATION
Install Battery
Press battery into
control aligned as
shown. Observe
SNAP PLUG proper polarity.
SOCKET
Replace the
battery door.
WOOD
SCREW
SCREW
6-32 X 1"
6-32 X 3 / "
8
1"
(2)
(2)
Control Storage
Angle control in top first in
the holder until the unit
can be gently pushed back
and snapped onto the
bottom rim.
Removing
Gently Pull the lower edge
of the control gently out
from the holder.
GUIDE SLOTS
SCREW
(2)
OUTER
MOUNTING
HOLES
TOP GOES
IN FIRST
11