Set Snmp Trap Addresses - Cabletron Systems RoamAbout User Manual

Set SNMP Trap Addresses

To have the AP send SNMP traps, you need to enter the IP address of the device where
the trap is to be sent. A trap is a defined event or condition detected by the RoamAbout
Access Point SNMP agent.
To enter an SNMP trap address using the console port:
1) At the RoamAbout Installation Menu, choose Add SNMP Trap Addresses.
2) Enter the SNMP trap address.
To delete an existing trap address using the console port:
1) At the RoamAbout Installation Menu, choose Delete SNMP Trap Addresses.
2) Enter the existing SNMP trap address that you wish to delete.
Note: To not change the existing value, press Return to go back to the previous
menu.
Note: To not change the existing value, press Return to go back to the previous
menu.
Configuring the AP for SNMP Management
Configuring the RoamAbout Access Point 4-19