Table of Contents
Advertisement
Using the LEDs to Determine the Problem
Table 5-2: LED Problem Solving Summary (Continued)
If...
Wireless LAN Activity
LED (6) is blinking a short
on once per second.
Bridge State LED (4)
is off.
Bridge State LED (4) is
blinking.
PC Card Present LED (7)
is off.
5-4 Problem Solving
Then...
There is no activity on
the wireless LAN. If
you know there is
activity on the wireless
LAN, then this status
indicates that the PC
Card has an incorrect
wireless parameter or is
not operating properly.
Self-test in progress or a
spanning tree
reconfiguration is
underway.
Otherwise, this status
may indicate that there
is a redundant AP
handling the network
traffic and that this AP
is in Standby mode.
Downline load is in
progress.
There is no PC Card
installed in the slot, or it
is not properly inserted.
Do This...
Reconfigure the wireless
parameters. Ensure that
the AP and all wireless
clients in the AP's
coverage area have the
same wireless parameters.
Verify that the PC Card is
installed properly.
Wait until self-test or
reconfiguration ends.
If the AP is in Standby
mode, verify your
network configuration to
determine whether there is
another AP configured to
operate in the same
coverage area.
Wait for downline load to
complete.
Turn off power and insert
the PC Card into the AP.
Advertisement
Table of Contents
