Seating The Ap In The Multiswitch 900 Or Dechub 90 - Cabletron Systems RoamAbout User Manual

Installing the AP into a MultiSwitch 900 or DEChub 90

Seating the AP in the MultiSwitch 900 or DEChub 90

You can install the AP in the MultiSwitch 900 or DEChub 90 without turning off
power. Seating the AP initiates the power-up sequence. However, when installing the
AP into a DEChub 90, connect the console port device to the console port before
applying power to the AP.
Perform the following steps to install the AP in the MultiSwitch 900 or DEChub 90.
Step
1
2
3
4
5
3-4 Installing the RoamAbout Access Point
Action
Place the AP's mounting tab into the first mounting slot on the
MultiSwitch 900 or DEChub 90.
Pivot the AP on the mounting tab and align the connectors.
Firmly push the AP onto the backplane connectors until the release lever
clicks.
Press down on the release lever to ensure that it is locked.
Release Lever
Clicks when
Module is
Seated.
Mounting Tab
Perform the appropriate steps in "Installing the AP" on page 3-5.
Hub Manager
Status Display
MultiSwitch 900
DEChub 90
LKG-9453-941-01