Showing Current Settings - Cabletron Systems RoamAbout User Manual

Showing Current Settings

Showing Current Settings
You can display the settings that the AP is currently using.
Using the AP Manager, select the AP in the Managed List field and click the various
buttons, such as Wireless Parameters, Operating Modes, IP Network Parameters,
and Hardware.
In the Wireless Parameters dialog, click the Advanced button to view all the wireless
parameters. If you see a Normal button instead of Advanced, the dialog is currently
displaying all the wireless parameters. If you have changed any wireless parameters
and have not yet reset the AP, the operating (current) settings are displayed on the left
and the settings that will take affect after the next reset are on the right.
Using the console port, choose Show Current Settings to display the current AP
settings, as shown below.
=================================================================
RoamAbout Access Point,Wireless-to-Wired Bridge:HW=V1.0,RO=V1.4,SW=V4. n
SysUpTime
SNMP Read/Write Community
Console Password
SNMP Trap Addresses
In-Band Interface Hardware Address
In-Band Interface IP Address
In-Band Interface Subnet Mask
In-Band Interface Default Gateway
Wired Ethernet MAC Address
Wireless Ethernet MAC Address
Wireless Network Adapter
Adapter Revisions
Bridge Mode
Upline Dump
Memory
===================================================================
4-4 Configuring the RoamAbout Access Point
: 00:26:37
: public
: Disabled
: Not Configured
: 08-00-2B-A3-89-61
: 16.20.40.156
: 255.0.0.0
: Not Configured
: 08-00-2B-A3-89-61
: 00-60-6D-92-00-FB
: RoamAbout IEEE 2.4 GHz DS
: Hardware 2.000 Firmware 3.01
: Work Group
: DISABLED
: 4194304 bytes
Press Return for Main Menu ...
98 resets