Installing The Ap Into A Multiswitch 900 Or Dechub 90; Removing The Back Cover - Cabletron Systems RoamAbout User Manual

Installing the AP into a MultiSwitch 900 or DEChub 90

This section describes how to install the AP in a MultiSwitch 900 or DEChub 90.

Removing the Back Cover

If there is a cover on the back of the AP, you must remove it before inserting the AP
into the backplane. Perform the following steps to remove the back cover:
Step
1
2
Installing the AP into a MultiSwitch 900 or DEChub 90
Action
Lift up the latch on the back cover by inserting a flat-blade screwdriver
into the top mounting hole.
With the latch up, pull the top of the back cover away, pivoting at the
bottom of the AP.
Installing the RoamAbout Access Point 3-3
LKG-6722-921-01