Installing The Ap - Cabletron Systems RoamAbout User Manual

Installing the AP

Perform the following procedure to install the AP as a standalone module. Also, you
may need to perform steps 4 and 5 after installing the AP in a DECHub 90 or
MultiSwitch 900.
Step
1
2
Action
Place the AP in the previously defined location. Site requirements are
defined in Chapter 2.
Connect the AP to the wired network using either the 10BaseT or
ThinWire connector, as follows:
To Connect to ThinWire Network –– Connect a ThinWire cable,
T-connector, and terminator to the BNC connector on the AP. Note that
instead of a terminator, the other side of the T-connector can be cabled
to another device in the LAN.
50-ohm
Terminator
A c c
T-Connector
e s s
P o in
t
1
2
LKG-8685-931-01
Installing the RoamAbout Access Point 3-5
Installing the AP