Table of Contents
Advertisement
To change or delete the Access Point's current IP address using the AP Manager:
1) Select the Access Point in the managed list.
2) Click the IP Network Parameters button.
3) Set the Address State to Volatile then click OK.
4) In the main AP Manager window, click the Reset/Reload button. Then click Reset
with Current Settings. This will set the IP address back to 0.0.0.0. The Access
Point is no longer manageable by the AP Manager.
5) Use the Setup/Add New Access Point button to give the Access Point a new IP
address and add it back to the list of managed Access Points.
To enter the AP's IP address, subnet mask, and default gateway using the console
port:
1) At the RoamAbout Installation Menu, choose Set In-Band Interface IP Address.
2) Enter the IP address, subnet mask, and default gateway. You do not need to reset
the AP.
Configuring the AP for SNMP Management
Configuring the RoamAbout Access Point 4-17
Advertisement
Table of Contents
