Configuring The Ap For Lan-To-Lan - Cabletron Systems RoamAbout User Manual

Configuring the AP for LAN-to-LAN

To configure two APs to communicate with each other in a LAN-to-LAN
configuration, perform the following tasks:
1) Get the wireless MAC address of the remote AP.
2) Set the Bridge Mode to LAN-to-LAN, as described in "Setting Bridge Mode" on
3) Make sure that the APs use the same channel. To change the AP channel, see
4) Set the Transmit (TX) Rate to Auto Select, which is the default setting. See
5) Perform this procedure on the other AP.
The following AP parameters are not used in this mode:
You can see the wireless address via the AP Manager or console device, as
described in "Showing Current Settings" on page 4-4. The wireless MAC address
is NOT the same as the wired MAC address printed on the front of the AP.
page 4-10.
"Wireless Parameters" on page 4-6.
"Wireless Parameters" on page 4-6 to change the Transmit Rate.
Wireless Network Name
Secure Access
AP Density
Power Management (DTIM Period)
Configuring the AP for LAN-to-LAN
Configuring the RoamAbout Access Point 4-15