Table of Contents
Advertisement
3. Hardware Installation
Start up
Please refer to the followings for your cabling:
10/100/1000Base-TX
All
10/100/1000Base-T
automatically support 1000Base-T, 100Base-TX and 10Base-T networks. Users only
need to plug a working network device into one of the 10/100/1000Base-T ports,
and then turn on the GSD-808HP. The port will automatically runs in 10Mbps,
20Mbps, 100Mbps or 200Mbps and 1000Mbps or 2000Mbps after the negotiation
with the connected device.
Cabling
Each 10/100/1000Base-T ports use RJ-45 sockets -- similar to phone jacks --
for connection of unshielded twisted-pair cable (UTP). The IEEE 802.3 / 802.3u
802.3ab Fast / Gigabit Ethernet standard requires Category 5 UTP for 100Mbps
100Base-TX. 10Base-T networks can use Cat.3, 4, 5 or 1000Base-T use 5/5e/6 UTP
(see table below). Maximum distance is 100meters (328 feet).
Port Type
10Base-T
100Base-TX
1000Base-T
Any Ethernet devices like hubs/ PCs can connect to the GSD-808HP by using
straight-through wires. The eight-10/100Mbps ports are auto-MDI/MDI-X can be
used on straight-through or crossover cable.
ports
come
with
Cable Type
Cat. 3, 4, 5, 2-pair
Cat. 5, 5e UTP, 4-pair
Cat.5/5e/6 UTP, 4-pair
Auto-Negotiation
capability.
They
Connector
RJ-45
RJ-45
RJ-45
11
Advertisement
Table of Contents
