Table of Contents
Advertisement
3.1 Desktop Installation
To install the Switch on desktop, simply follow the next steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the Switch,
as shown in Figure 3-1.
Figure 3-1: Attaching the Rubber Feet to the PoE Fast Ethernet Switch
Step 2: Place the Switch on desktop near an AC power source.
Step 3: Keep enough ventilation space between the Switch and the surrounding
objects.
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4, in Specification.
Note
Step 4: Connect your Switch to 802.3af / 802.3at complied Power Devices (PD)
and other network devices.
A. Connect one end of a standard network cable to the 10/100/1000
RJ-45 ports at front panel of the Switch.
B. Connect the other end of the cable to the network devices such as
printer servers, workstations or routers...etc.
Connection to the Switch requires UTP Category 5, 5e, 6 network
cabling with RJ-45 tips. For more information, please see the
Cabling Specification in Appendix A.
Note
Step 5: Supply power to the Switch.
A. Connect one end of the power cable to the Switch.
B. Connect the power plug of the power cable to a standard wall outlet.
When the Switch receives power, the Power LED should remain solid Green.
12
Advertisement
Table of Contents
