4. Hardware Installation
4.1 Wall-mount Installation
To install the Wall-mount Managed Switch on the wall, simply follow the
following steps:
Step 1: Drive four 8mm diameter holes into the wall horizontally with
the distance between the 2 holes is 133mm (WGS-804HPT/
WGS-4215-8T),
230mm (WGS-4215-16P2S) Refer to the table below.
Step 2: Lightly hammer the wall anchors into the four holes.
Step 3: Place the unit on the wall where there are four holes, and screw the
bolts into the wall anchors to finish the installation.
Distance (mm)
W
D
8
163mm
(WGS-4215-8T2S/WGS-4215-8P2S)
Hole sizes for mounting
8-port
133
118
8+2S
163
118
and
16+2S
230
124