Peak Pilates Cadillac Assembly & User's Manual page 6

Reformer Mode Assembly
Place the Cadillac Convertible frame in the location where
It will be used.
1. Installing the Carriage:
This step is best performed by two people. The carriage is
outfitted with a carriage stabilization block that is mounted on
the back/right wheel bracket on the underside of the carriage.
The carriage stabilization block has a safety roller which will
prevent the carriage from tilting upward within the frame
should the front part of the carriage be subjected to excessive
weight.
Standing to the right side of the reformer frame, tilt the
carriage (the side on which the carriage stabilization block
is mounted) toward the left side of aluminum track. Place
the tilted edges of the wider wheels on the track, with the
nylon safety roller below the track; now, lower the other side
of the carriage into the frame. The nylon safety roller should
automatically slide into place underneath the aluminum track
(if the safety roller ends up on top of the track, remove the
carriage and reinstall).
2. Installing the Spring Bar:
Your Cadillac Convertible has a 4 gear system: -1, 1, 2 and 3.
The -1 location is the slot closest to the foot end of the frame.
Place the round spring bar into 1st gear – the second slot from
the foot end – and insert the gear block into the first hole in
the right side track. Make sure that the hooks assembled to the
spring bar are oriented as shown in the photo.
Note: The gear block is not used when the spring bar
is in position -1.