Peak Pilates Cadillac Assembly & User's Manual page 14

Adjustable Footbar System
Optional Jump Board & Removable Sidesplit Platform Installation
5
Your Cadillac Convertible comes equipped with a 4-position adjustable
footbar system. The u-shaped footbar support bar swings between the legs
of the footbar. Position - according to preference - the footbar support bar
on one of the ledges mounted on the inside of the cross member located at
the foot of the Cadillac Convertible.
The two black knobs in the metal component located on the inside of the
cross member at the foot of the Cadillac Convertible frame are the locking
knobs for securing the jump board or sidesplit platform.
Installing the Jump Board:
1. If using a standard jump board, first position the u-shaped footbar
support bar (the bar that pivots inside the footbar) so it rests on the 2nd
position ledge of the metal bar just in front of the slot into which you will
insert the tongue of the jump board.
2. Insert the tongue of the jump board into the slot between the metal bars
and the wood of the foot end cross member. Make sure that the side of the
tongue of the jump board that has two steel disks is facing the carriage.
NOTE: For safety and warranty reasons the footbar must be used
to stabilize the jump board as shown in the photograph.
NOTE
3. Tighten the black knobs against the steel disks in the tongue. (Remember
to loosen the knobs before attempting to remove the jump board to prevent
damaging it.)
Installing the Sidesplit Platform:
4. Place the footbar in position 4.
5. Insert the tongue of the sidesplit platform into the slot between the metal
bars and the wood of the foot end cross member. Make sure that the side of
the tongue of the sidesplit platfrom that has two steel disks is facing the
carriage.
6. Tighten the black knobs against the steel disks in the tongue.
(Remember to loosen the knobs before attempting to remove the sidesplit
platformto prevent damaging it.)