Activate Remote Control/Change Remote Pin; Remote Activation; Remote Control - Doro TH70 Manual

Activate remote control/Change remote PIN

Every time the remote control is activated a new PIN code must be set. If the remote PIN
code is forgotten it can be reset to 0000 by doing a reset of the base unit in Base settings.
However everything in the base unit will be deleted. The registration and handset phone
book are however not deleted.
1. Press Menu. Scroll to Answer machine. Press OK.
2. Scroll to Remote access. Press OK.
3. Scroll to required setting e.g. Enable. Press OK.
4. Enter the remote PIN code (0000 on delivery). Press OK.
5. Enter the new remote PIN code. Press OK.
6. Repeat the new remote PIN code. Press OK.

Remote activation

If you have forgotten to turn the machine on, you can do so by remote access.
1. Call the answer machine. It will answer after 10 rings (Australia 16 rings).
2. Enter the RemotePIN code (see previous page). One beep confirms correct code.
3. Any new messages are played back, or press
4. Press (off=2 beeps, on=1 beep).
0
5. Hang up.

Remote control

This machine can be remote controlled using the keys of an ordinary tone dialling phone.
1. Call the answer machine.
2. Press when the outgoing message is played.
*
3. Enter the RemotePIN code (see previous page). One beep confirms correct code.
4. Any new messages are played back, or press
5. Select a remote control command, see below.
6. Hang up.
Command
1 .......................... Stop
2 .......................... Play all messages
3 .......................... Play new messages
4 .......................... Repeat/skip to previous message
5 .......................... Erase single message during playback
6 .......................... Skip to next message
7 .......................... Select answer mode (normal=2 beeps, only otg msg=1 beep)
8 .......................... Playback of outgoing message
9 .......................... Record new outgoing message, Stop=#
0 .......................... Turn TAM off/on (off=2 beeps, on=1 beep)
Please note!
If the machine doesn't respond to the remote control commands, try pressing the telephone
buttons for a longer or shorter time. In normal cases, the answer machine should react to tones
approximately 0.5 – 1 seconds in length, but longer tones may be necessary in certain telephone
networks.
English
Function
to stop.
1
to stop.
1

. If the remote PIN