Appendix A: Restore Factory Default Settings - Planet IVS-100 User Manual

IVS-100 User's manual
Appendix A: Restore Factory
Default Settings
There is a button hidden in the pinhole above the Alarm I/O connector. It is used to
restore the factory default settings. Sometimes restarting IVS-100 will make the system
back to a normal state. If the system still got problems after reset, user can restore the
factory default settings and install it again.
Restore IVS-100:
1. Power off IVS-100.
2. Insert the paper clip or other tool and press and hold the button down
continuously.
3. Power on IVS-100 again.
4. Wait at least 8 seconds and release the tool. Then IVS-100 has been restored
to default settings.
Note: Restoring the factory default setting will lose the all-previous settings forever. User
needs to run the IP Finder program to search IVS-100 and configure it to let IVS-100
work properly again.
62/79