Assembly - ProForm 620 Zlt Treadmill User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
1. Make sure that the power cord is unplugged.
Remove and discard the two screws (A) and
the shipping bracket (B) from the right side of
the Base (74). Then, remove and discard the
screws and shipping bracket (not shown)
from the left side of the Base.
2. Locate the Upright Wire (63) bundled around the
front of the Base (74). Cut the plastic tie securing
the Upright Wire. Pull the end of the Upright Wire
out of the indicated hole.
See the inset drawing. Cut the plastic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire.
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
scissors
• To avoid damaging parts, do not use power tools.
1
2
Hole
7
B
74
74
Cut
Tie
63
Cut
63
A