ProForm 620 Zlt Treadmill User Manual page 10

7. Set the console assembly face down on a soft
surface to avoid scratching the console.
Loosen the four #8 x 1" Screws (7). Carefully
pivot the Console Frame (61) to the position
shown.
Identify the Left and Right Trays (90, 60). Attach
the Trays to the console assembly with eight
M4.2 x 13mm Screws (65).
Carefully pivot the Console Frame (61) back
down to the console assembly.
8. Identify the Right Handrail (64). Remove the tie
from the Right Handrail. If necessary, press the
M8 Cage Nut (85) back into place.
Hold the Right Handrail (64) near the console
assembly. Use the tie on the console wire to pull
the wire around the side of the Right Handrail
and through the slot in the Right Handrail as
shown.
If necessary, adjust the Console Frame (61) to
align the holes in the Right Handrail (64) with the
holes in the Console Frame.
Attach the Right Handrail (64) to the Console
Frame (61) and the console assembly with two
M8 x 25mm Bolts (5), two M8 Star Washers (6),
and an M5 x 16mm Screw (23) with a 1/4" Star
Washer (8). Make sure that the console wire is
not pinched. Start both Bolts and the Screw
before tightening any of them.
Attach the Left Handrail (not shown) as
described above. Note: There is not a wire on
the left side.
Tighten the #8 x 1" Screws (7). Be careful not
to overtighten the Screws.
7
90
61
8
Tie
23
Console
Assembly
10
65
65
60
7
Console Assembly
Console
Wire
85
Tie
8
Slot
7
5
6
64
61