ProForm 620 Zlt Treadmill User Manual page 11

9. Have a second person hold the console assembly
near the Right Upright (76).
Connect the Upright Wire (63) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED
ON. Remove the long tie from the Upright Wire
and the tie from the console wire. Then, insert the
connectors into the Right Upright (76).
Set the console assembly on the Right Upright
(76) and the Left Upright (not shown). Make sure
that no wires are pinched.
10. Start an M8 x 25mm Bolt (5) and two 5/16" x 5/8"
Screws (79) with two M8 Star Washers (6) into
the Right Upright (76) and the Right Handrail
(64) as shown. Do not tighten the Bolt and
Screws yet.
Attach the Left Handrail (not shown) as
described above. Then, firmly tighten both
Bolts and all four Screws.
9
Console
Assembly
Tie
Console Wire
63
Long
Tie
76
10
64
5
11
Console
Wire
63
79
6
76