Transparency Unit Start Button; Installing The Transparency Unit - Epson EXPRESSION 1640XL User Manual

Note:
Before transporting the scanner, remove the Transparency Unit and
replace the shipping screws in the outer, transportation holes.
If the unit's lamp assembly is not in its home position, you cannot
replace the shipping screws. If this is the case, reattach the unit to
the scanner, close the unit, and turn the scanner on; the unit's lamp
assembly then returns to its home position. Turn off the scanner and
remove the Transparency Unit.

Transparency Unit Start button

The Transparency Unit Start button makes it possible to operate
the scanner's Start button while using the Transparency Unit.

Installing the Transparency Unit

Follow the steps below to install the Transparency Unit.
1. Make sure the scanner is turned off and unplug the power
cable from the scanner.
2. Remove the document cover from the scanner by holding the
cover behind the hinge and lifting the back of the cover
straight up. See"Removing the Cover for Thick or Large
Documents" on page 4-5.
6-4
Options