The Scanner Turns Off; You Cannot Start Epson Scan; Pressing A Scanner Button Does Not Start The Correct Program - Epson Perfection V600 Photo User Manual

The Scanner Turns Off

❏ Make sure the Power Off Timer is set. For more details, see "Power Off Timer Setting" on
page 133.

You Cannot Start Epson Scan

❏ Wait until the blue status light stops flashing to indicate that the scanner is ready to scan.
❏ Make sure the scanner is turned on.
❏ Turn off the scanner and computer, then check the interface cable connection between them to
make sure it is secure.
❏ Use the USB cable that came with your scanner or that is indicated in "USB Interface" on
page 163.
❏ Connect the scanner directly to the computer's USB port or through one USB hub only. The
scanner may not work properly when connected to the computer through more than one USB
hub.
❏ Make sure your computer supports USB.
❏ If you are using any TWAIN-compliant program, make sure that the correct scanner is selected as
the Scanner or Source setting.
❏ If you upgraded your computer's operating system, you need to reinstall Epson Scan. Uninstall
Epson Scan as described in "Uninstalling Your Scanning Software" on page 146, then reinstall it as
described in the paper manual.
For Windows only:
Make sure your scanner's name appears under Imaging device without a (?) or an exclamation (!)
mark in the Device Manager window. If the scanner's name appears with one of these marks or as an
Unknown device, uninstall Epson Scan as described in "Uninstalling Your Scanning Software" on
page 146, then reinstall it as described in the paper manual.

Pressing a Scanner Button Does Not Start the Correct Program

❏ Make sure Epson Scan is installed correctly.
Perfection V600 Photo
Troubleshooting
User's Guide
136