Fig. 18 Starting The Descaling Programme Coffee-Making System; Fig. 19 Coffee-Making System Asks For Descaling Solution - BRAVILOR BONAMAT B5HW Operating Instructions Manual

7.2.3 Starting descaling
programme
coffee–making system
– Make sure that the spray head is in the
correct position above the empty container
with empty filter unit.
– Desolve 100 g of descaler in 0.75 litre
lukewarm water (about 40°C). Stir the
descaling solution, so that it is well desolved.
– When during the descaling programme a
signal sounds, an operation is to be carried
out. Finish the operation by pressing the
confirmation key (L.).
– When the level blocks on the display start
flashing, the coffee container is to be
emptied.
G
H
I
J
K L M
Fig. 18 Starting the descaling programme
coffee–making system
D After having entered the operators' PIN code,
press selection key (M.)⇓ twice.
– The descaling programme appears on the
display (fig.18 ).
D Press programming key (G.).
– The symbol dP starts flashing and the enter
symbol ↵ appears on the display.
D Press confirmation key (L.) to start the
descaling programme.
– A flashing hammer symbol appears on the
display.
– The waterreservoir is boiled empty and this
water flows into the coffee container.
– A signal sounds and the level blocks on the
display flash, indicating that the container
must be emptied.
ECopyright Bravilor Bonamat B.V.
TIP
– Stopping the programme
– After 5 seconds (when the stop symbol key
– The programme can still be left by pressing
– After pouring in the descaler solution this is
D Empty the coffee container through the tap (AB.).
D Press the confirmation key (L.) to confirm that
the container is empty.
– A flashing hammer symbol appears on the
– The waterreservoir is boiled empty and this
– A signal sounds and the level blocks on the
D Empty the coffee container through the tap (AB.).
D Press the confirmation key (L.) to confirm that
the container is empty.
– A signal sounds, the hammer symbol flashes
N
G
H
I
J
Fig. 19 Coffee–making system asks for descaling
D Remove the plug of the filling hole for descaler
solution (B.).
– The filling hole of the coffee–making system
D Place the special funnel in the filling hole and
carefully pour the descaler solution into the
filling hole.
Within 5 seconds (when the stop symbol
above key (K.) still flashes):
D press key (K.).
above key (K.) has stopped flashing):
D Hold programming key (G.) down until
fig. 18 re–appears on the display.
the red stop key.
no longer possible!
display.
water flows into the coffee container.
display flash, indicating that the container
must be emptied.
and a funnel appears on the display (fig.19 ).
K L M
solution
is found behind the spray head (D.).
version
N
21
1.0