Timer; Fig. 44 Pre-Programmed Settings (Inactive); Fig. 45 Pre-Programmed Setting (Active) - BRAVILOR BONAMAT B5HW Operating Instructions Manual

7.3.8

Timer

There are fourteen pre–programmed "time
settings" for all days of the week. As soon as
these are activated through the procedure below,
they will only be active and visible in the user
mode. All settings can be set as desired. The
fourteen settings are default (fig. 44 ):
– Settings 1–14 on MO (English)
– OFF, inactive
– the maximum amount
– 7.00 hours
G
H
I
J
M
K L
Fig. 44 Pre–programmed settings (inactive)
The time settings are changed as follows:
D Press selection key (N.)⇑ until fig.44 appears
on the display.
D Press confirmation key (L.) to access the
programme.
D Press selection key (M.)⇓ or (N.)⇑ to select the
desired time setting (1–14).
D Press programming key (G.).
– The position beside the programming key
starts flashing.
D Press selection key (M.)⇓ or (N.)⇑ to select the
desired day (table 10 , § 7.3.7.2).
D Press programming key (I.).
D Press selection key (M.)⇓ or (N.)⇑ to select the
desired amount.
D Now press programming key (J.) to set the
desired time.
– The first two positions beside the
programming key are flashing.
D Press selection key (M.)⇓ or (N.)⇑ to set the
desired hour.
D Press again the programming key (J.) to set
the minutes.
– The last two positions beside the
programming key are flashing.
ECopyright Bravilor Bonamat B.V.
D Press selection key (M.)⇓ or (N.)⇑ to set the
desired minutes.
– If all settings are as desired, the setting can
D Press programming key (H.).
– OFF is changed into ON.
– The setting can now be selected in the user
– The enter symbol ↵ appears on the display.
D Press confirmation key (L.) to confirm.
– The desired time has been set now.
– This procedure can be repeated for 14
D Press selection key (N.)⇑ to go to the next time
setting (1–14) and repeat the above procedure.
D Press stop key (K.) and subsequently selection
key (N.)⇑ to go to the next setting § 7.3.9 or
press stop key (K.) twice to exit the
programming menu.
D Put the setting to ON to make the setting
selectable in the user mode. If the setting is on
OFF, the setting cannot be selected in the user
mode, see § 7.1.1.
N
G
H
I
J
Fig. 45 Pre–programmed setting (active)
be put from OFF to ON.
mode.
pre–programmed time settings in total.
K L M
version
N
35
1.0