Flushing The Coffee-Making System; Fig. 6 Activating The Hw System; Fig. 7 Display With The Default Options - BRAVILOR BONAMAT B5HW Operating Instructions Manual

– If the water temperature has been set below
the maximum (97 °C, at sea level) (§ 7.3.6.1)
the above no longer applies.
WARNING
n Do not touch the cover during the automatic
boiling point approach at the risk of burning.
G
H
I
J
M
K L

Fig. 6 Activating the HW system

8
version 1.0
3.2.2.2
D Place the filter unit (T.) on the coffee container
D Turn the spray head (D.) above the hole in the
D Switch the ON/OFF switch (P.) on.
D Push the selection key for amount 2 (H.).
As soon as the hot water supply through the
spray head has stopped, the filter pan in the
display starts flashing. This means that the
N
dripping–on time has started. (Only when the
dripping–on time is set). The dripping–on time is
standard set to 2 minutes. After the dripping–on
time has terminated, a signal sounds (3 short
beeps) indicating that the coffee–making process
has finished.
D Tap the water through the coffee tap (AB.).
D Turn the spray head above the filter unit of the
D Repeat the above steps for the other coffee
After that the coffee–making system is ready for
use (chapter 4.)
G
H
I
J

Fig. 7 Display with the default options

Flushing the coffee–making
system
(Y.).
cover (U.) of the filter unit (T.).
– The indicator lamp in the switch lights up.
The default options appear in the display
(fig. 7 ).
– A signal sounds. The coffee–making
process is started. The selected amount
flashes in the display.
other container.
container.
K L M
ECopyright Bravilor Bonamat B.V.
Ó Ó
N