Mirage DSK-1 Manual page 55

set up all the parameters necessary to create a wavetable made up of a single wavesample. When
you want more than one wavesample to make up a wavetable, you will have to set the sampling
parameters on your own, after setting this switch to ON.
78/LFO Modulator Source (0-9)
The LFO depth can be modulated by external controllers such as After Touch and Breath
Controller when the Mirage is played from another keyboard via MIDI. The default value is 1,
which selects the Modulation wheel. To select an external controller for LFO depth, set the value
of this parameter to the appropriate value, Possible values are:
79/Mix Modulator Source (0-9)
The MIX between the two oscillators (for chorusing or mixing between two samples in Mix
Mode) can also be controlled by external controllers when the Mirage is played from another
keyboard via MIDI. Possible values are the same as for Parameter 78 above. Note: To use an
external controller for MIX Modulation, you must also set the value of parameter 32 on the
Mirage to 0.
80/After Touch Modulation depth (0-63)
This controls the depth or amount by which After Touch will affect the MIX or LFO Depth when
After Touch has been selected as an external controller at parameter 78 or 79. Unless one of
those parameters is assigned a value of 8 or 9, this parameter will have no effect.