Changing Sounds - Mirage DSK-1 Manual

CHANGING SOUNDS

CHANGING SOUNDS
Once the Mirage is up and running, there is a slightly different procedure to change sounds, Once the Mirage is up and running, there is a slightly different procedure to change sounds, Once the Mirage is up and running, there is a slightly different procedure to change sounds,
either loaded from the same diskette or from a different diskette. either loaded from the same diskette or from a different diskette.
Do this... Here's what's happening...
Press LOAD Before loading the actual sound Before loading the actual sound
button(s) either information, you must s information, you must select whether
UPPER, the sound wi11 be available on the the sound wi11 be available on the
LOWER or both upper half of the keyboard, the lower upper half of the keyboard, the lower
half, or the entire keyboard. half, or the entire keyboard.
Press 1, 2, or 3 Each diskette has three sounds, Upper Each diskette has three sounds, Upper
on the SELECT and Lower. Refer to the diskette label and Lower. Refer to the
Keypad for a description of each. for a description of each.
CANCEL If you change your mind about which If you change your mind about which
sound you wish to load, press sound you wish to load, press
CANCEL and begin again. CANCEL and begin again.
- OR - This will initiate the transfer of This will initiate the transfer of
ENTER information from the diskette to the information from the diskette to the
Mirage memory Mirage memory
Wait a maximum Loading a sound into the memory of Loading a sound into the memory of
of 8 seconds both halves of the keyboard will take both halves of the keyboard will take
about 8 seconds. about 8 seconds.
at's happening... Display will show...
LU (load upper) or LL LU (load upper) or LL
(load lower) or LA
(load all). Flashing
L1 (Load l) or L2
(Load 2) or L3 (Load
3). Flashing
Previous parameter
before pressing Load
button
Display blank
Drive light on
When the Load is
completed, the number completed, the number
of the last used