Mirage DSK-1 Manual page 10

To run the Mirage in mono connect this jack to your mixer or amplifier. When nothing is
plugged into the Right Output, all audio will be routed to this output. When using the Mirage in
stereo, connect this jack to one channel of your mixer and pan that channel left. Specs: Same as
Right Audio Out
Audio input switchable between line and mic levels, Parameter 75 (LINE INPUT ON/OFF)
controls the level select. The line level input wi11 accept signals of up to 1 V, impedance 20K
ohms. The mic level input will accept signals of up to 100mV, impedance 200K ohms,
This connection is for the Sustain Pedal/ foot- switch (Model SW-1), Its function is controlled by
parameter 89 (SUSTAIN PEDAL/FOOT- SWITCH SELECT).
This jack sends out Musical Instrument Digital Interface (MIDI) information from the Mirage to
other instruments and computers. In the MIDI THRU MODE (parameter 83), it also echoes all
MIDI inputs.
The input for MIDI information. The MIDI IN jack is controlled by parameter 81 (MIDI OMNI
MODE ON/OFF), and parameter 82 (MIDI CHANNEL SELECT).
1 Amp fast-blow Fuse socket.
The supplied AC line cord should be connected here. The correct voltage for the Mirage is listed
on the Serial Number label on the rear panel. If you travel, remember that the Mirage will only
operate on this voltage.
Rocker switch to turn power on and off.