NetComm N300 User Manual page 16

- The time zone should be set correctly by default, if it is not, please select your Time zone from the pull down menu and click "Next".
- Select whether you would like to automatically detect your primary WAN connection type or set the connection type manually (3G USB
modem or wired WAN) and then click "Next".
- There are a number of different connection types available. Select the type of connection which is appropriate for your broadband service.
You can choose from the following connection types:
• 3G Connection
• Ethernet WAN
o Static IP Address
o Dynamic IP Address
o PPP over Ethernet
o PPTP
o L2TP
The example below shows the 3G connection setup.
(Each connection type has different configuration requirements. Some require a server address and username / password account details, while others may only require the correct
APN [in the case of a 3G connection] to be entered)
Please refer to the relevant connection type configuration section in the later chapters of this user manual for more information
about configuring the different connection types offered.
After entering the connection details supplied by your Broadband service provider, click the "Next" button.
- If you want to change the wireless network name or channel settings, you can do so on this page. Change the settings as needed and
click "Next".
(If you wish to use the default settings, click "Next")
3G18WV User Guide
16
YMLO-3G18WV
www.netcomm.com.au