Drying Programme Finished - Electrolux TW SL3 M100 Operating Instruction

Tumble drying
6

Drying programme finished

The compressor's cooling fan continues to
run after the programme finishes, but stops
automatically or when any button/knob is
activated.
The text "Done" appears on the display when the
programme is finished.
Backlighting
Two minutes after the drying programme finishes
the backlighting on the display and option buttons
enters energy saving mode.
Condensed water
The condensed water container must be emptied
after each load. Remove the condensed water
container, empty out the water and replace the
container. If the condensed water container
becomes full to overflowing, the programme is
interrupted and "Over Flow" appears on the
display. Empty the container and press the Start
button to start a new programme.
TIP!
The condensed water is decalcified and can be
used in steam irons. Pour it through a coffee
filter.
Automatic emptying
For connection to a separate drain, see the
installation instructions in the set of documents.
NOTE!
• Clean the lint filter after each load.
• Drain the tank after each load.
WARNING!
If the lint filter becomes clogged, the machine's
automatic overheating cut-out may be triggered.
In order to be able to restart the machine, you
must clean the filter and allow the machine to
cool down for around 30 minutes.
Once drying has finished
Turn off the main power switch. Remove the
clothes and close the door to prevent small
children from climbing into the machine.
13